Yaskawa PC NC - Manual (Page 228)

A2 - 17
YASNAC PCNC Operating Manual Appendix 2: Alarm Tables
Alarm
No.
Description
alarm.3222 Disconnection in wiring to the separately installed PG (2nd-axis)
alarm.3223 Disconnection in wiring to the separately installed PG (3rd-axis)
alarm.3224 Disconnection in wiring to the separately installed PG (4th-axis)
alarm.3225 Disconnection in wiring to the separately installed PG (5th-axis)
alarm.3240 Servo has been turned off due to turning ON of the ERR 2 signal.
alarm.3241 Absolute error (separately installed PG) has occurred (1st-axis).
alarm.3242 Absolute error (separately installed PG) has occurred (2nd-axis).
alarm.3243 Absolute error (separately installed PG) has occurred (3rd-axis).
alarm.3244 Absolute error (separately installed PG) has occurred (4th-axis).
alarm.3245 Absolute error (separately installed PG) has occurred (5th-axis).
alarm.3252 NMI interruption has occurred due to- the occurrence of bus gate error.
alarm.3253 NMI interruption has occurred due to- the occurrence of watchdog time-out.
alarm.3260 SH-INTEX synchronization error has occurred.
alarm.3261 SH-MOTION synchronization error has occurred.
alarm.3262 INTEX-MOTION synchronization error has occurred.
alarm.3263 MOTION-PLC synchronization error has occurred.
alarm.3264 MOTION-AXIS synchronization error has occurred.
alarm.3265 ACGC synchronization error has occurred.
alarm.3266 DNC synchronization error has occurred.
alarm.3270 Data error has occurred when turning the power OFF (battery backed-up memory).
alarm.3271 Data error has occurred when turning the power OFF (tool life control).
alarm.3272 Data error has occurred when turning the power OFF (macro).
alarm.3273 Data error has occurred when turning the power OFF (internal memory).
alarm.3274 Program has been destroyed due to turning the power off during editing (program).
alarm.3275 Data error has occurred when turning the power OFF during editing (custom variables).
alarm.3276
The power has been turned OFF during editing. This requires the program to be checked after turning
the power ON.
alarm.3281 YENET1200 command time-out error has occurred (1st-axis).
alarm.3282 YENET1200 command time-out error has occurred (2nd-axis).