Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 99)

26 October 2009 K2 Storage Area Network Installation and Service Manual 99
Configuring QOS on the GigE switch
20.If you have a trunk, verify that for the default VLAN the trunk is displayed in the
Tagged Ports column.
21.If you have two switches, repeat this procedure for the other switch.
22.Close the switch configuration application.
Configuring QOS on the GigE switch
Prerequisites for this procedure are as follows:
• The switch is HP ProCurve switch 29xx series.
• Trunks, VLANs and all other configuration is complete.
• The switch has an IP address
• You have network access to the switch
Use this procedure to make the Quality of Service (QOS) setting on the HP ProCurve
switch 29xx series.
1. If you have not already done so, from a network connected PC open the MS-DOS
command prompt and login to the switch as administrator, as follows:
a. Telnet to the switch. For example, if the switch’s IP address is 192.168.40.12,
you type the following, then press Enter .
telnet 192.168.40.12
b. Press Enter one or more times until the switch’s username prompt appears.
c. Type the switch’s administrator username and press Enter , then type the
switch’s administrator password and press Enter . The switch console command
(CLI) prompt appears.
2. Type the following, then press Enter :
config
You are now in configuration mode.
3. Type the following, then press Enter :
show qos vlan
The screen displays VLAN information. Note the ID number of the Media (iSCSI)
VLAN. It should be 60, as follows:
VLAN priorities
VLAN ID Apply rule | DSCP Priority
------- ----------- + ------ -----------
1 No-override | No-override
60 No-override | No-override
a. Assign the Media VLAN the QOS priority of 3. For example, if the VLAN ID
is 60, you type the following, then press Enter .