Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 225)

225 K2 Storage Area Network Installation and Service Manual 26 October 2009
2. Click the Configure button. The Configure K2 Storage System Server wizard
opens. Follow the on-screen text to configure the server for a Level 20R K2 SAN,
as described in the following table. Some screens require no input from you, as they
are based on the configurations already completed on a previously configured K2
Media Server.
On this page… Do this…
Define server roles
If the K2 SAN has one or
more optional NH servers,
then FTP traffic should go to
the NH server, not the K2
Media Server you are now
configuring. In this case, do
not select the FTP server role
or the NAS server role.
Enter the name for the K2 Media Server. This should be the current
network name of the machine.
Enter the name or IP address of the Ethernet switch, as currently
configured on the switch, to which the K2 Media Server is connected.
Select all roles, except if NH server is present do not select FTP server
or NAS server.
Click
Next
Software Configuration
This page checks for the
software required to support
the roles you selected on the
previous page.
If software with Yes in the Required column reports as Not Installed, you
must first install it on the K2 Media Server before continuing. After
installing the software, click
Check Software . When all required
software reports as Installed, click Next .