Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 72)

72 K2 Storage Area Network Installation and Service Manual 26 October 2009
Chapter 3 Cabling K2 SAN devices
Cabling the NH K2 Media Server for an online K2 SAN
NH1 K2 Media Server – Dell 1950 PowerEdge – Online K2 SAN
NH1 K2 Media Server – Dell R610 PowerEdge – Online K2 SAN
Connect the motherboard GigE port 1 (control) and GigE port 2 (FTP) to control
ports on the GigE switch. If you have more than one NH1 server, balance servers
between the A GigE switch and the B GigE switch.
Connect the Fibre Channel port to the RAID storage device. If you have more
than one NH1 server, balance servers between controller 0 and controller 1.
NH1-10GE K2 Media Server – Dell 1950 PowerEdge – Online K2 SAN
NH1-10GE K2 Media Server – Dell R610 PowerEdge – Online K2 SAN
Connect the motherboard GigE port 1 (control) to a control port on the GigE
switch. If you have more than one NH1-10GE server, balance servers between
the A GigE switch and the B GigE switch.
Connect the 10 Gig FTP port to the 10 Gig port on the rear of the GigE switch.
If you have more than one NH1-10GE server, balance servers between the A
1 2
Gb 2 Gb 1
Fibre Channel
to RAID controller To control port
on GigE switch FTP: To control port
on GigE switch
Fibre Channel
to RAID controller To control port
on GigE switch FTP: To control port
on GigE switch
1 2
Gb 2 Gb 1
FTP: To 10 Gig port
on GigE switch Fibre Channel
to RAID controller To control port
on GigE switch
FTP: To 10 Gig port
on GigE switch Fibre Channel
to RAID controller To control port
on GigE switch