beautypg.com

Configuring raid – Grass Valley K2 Summit Storage Area Network v.7.1 User Manual

Page 279

background image

279

K2 Storage Area Network Installation and Service Manual

26 October 2009

3. Continue with the next procedure to use Storage Utility to configure the storage

and file system.

Leave the Configure K2 Server wizard open while you are using Storage Utility.
When you are done with Storage Utility, you continue with the wizard.

Configuring RAID

Use Storage Utility to complete the configuration of the L30R RAID chassis, as
explained in the following topics:

“Configuring RAID network and SNMP settings”

“Binding disk modules”

Refer to

“Prerequisites for initial configuration” on page 274

to confirm that the

RAID storage is ready for configuration.

Network Configuration

This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
For Level 35, this server
does not take the role of FTP
server, so configuring the
second port here for the FTP/
streaming network is not
required.

The top port is the port over which the K2 System Configuration
application is communicating. If correctly configured, it is already
assigned the control network IP address, as displayed on this page.

Click

Next

.

File System Server
Configuration

Click

Launch Storage Manager

. Storage Utility opens.

On this page…

Do this…

This manual is related to the following products: