Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 489)

489 K2 Storage Area Network Installation and Service Manual 26 October 2009
Chapter 13 K2 FCP Connect access for Final Cut Pro systems
e. Verify that there is a "+" next the text file, plus a list of permissions below. If
this is true then cross-platform ACLs are enabled.
f. Open the Finder, go to the default volume and try to edit the text file. This
should fail as the file should not be writeable.
g. In the Finder, go to the folder you created earlier in this procedure and create a
text file in the folder. This operation should be successful.
h. Log out and then log back in as userB.
i. In the Finder, go to the folder you created earlier in this procedure and try to
create a text file in the folder. This operation should fail.
Configure HotBin
Configure a HotBin on the K2 SAN to receive the finished media from Final Cut Pro.
1. Set up SNFS as follows:
Add "GlobalSuperUser = Yes" to the SNFS configuration file.
2. In K2 AppCenter, create a bin with an appropriate name, such as "dstBin".
3. Configure dstBin as a HotBin.
Refer to the K2 System Guide for instructions.
4. When you configure a HotBin, in the Capture Services Utility you can adjust
QuickTime Import Delay. The recommended setting is 15 seconds. Refer to the
next topic for more information.