Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 415)

415 K2 Storage Area Network Installation and Service Manual 26 October 2009
Chapter 12 Administering and maintaining the K2 SAN
f. On the Hardware Installation page, click Continue Anyway .
g. Click Finish .
5. If the K2 Media Server has a dual port Fibre Channel card, on the Found New
Hardware wizard, install the driver on the second LSI Pseudo Device port as
follows:
a. Select Install from a list or specific location . Click Next .
b. Select Don’t search. I will choose the driver to install . Click Next .
c. Select Have Disk .
d. Browse to C:\profile\drivers\LSI_SCSIPORT_1.21.25.00. Click Open and OK .
e. Start the driver install by selecting Next .
f. On the Hardware Installation page, click Continue Anyway .
g. Click Finish .
6. Make the following registry settings:
[HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Service
s\Lsi_fc\Parameters\Device]
"DriverParameter"="MPIOMode=2"
"MaximumSGList"=dword:000000ff
"NumberOfRequests"=dword:000000ff
Recovering from a failed K2 Media Server system battery
The following procedure applies to K2 Media Servers based on the Dell 2850/2950
platform. K2 Media Servers on other Dell models can have similar procedures. Refer
to the service documentation on the Dell Documentation CD for specific procedures.
When the system battery in a K2 Media Server fails (non rechargeable) the system
configuration is lost, and the system will not complete startup processes when the
battery is replaced.
1. Restart the K2 Media Server.
A startup screen displays the message “Invalid configuration information - Please
run setup program. Time of day not set - Please run setup program.”
2. Press F2 to enter setup.
3. Set the system date and time
4. Select System Setup | Integrated Devices
5. Select RAID . This also sets ChA and ChB to RAID
6. Restart the K2 Media Server.
A startup screen displays the message “Warning: Detected mode change from
SCSI to RAID on ChA of the embedded RAID system.”
7. Select Yes .
A startup screen displays the message “Warning: Detected mode change from