Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 96)

96 K2 Storage Area Network Installation and Service Manual 26 October 2009
Chapter 4 Setting up K2 SAN infrastructure
9. Click Modify Selected Ports .
10.Make sure Port Enabled is set to Yes , leave Mode as default of Auto .
11.Set Flow Control as follows:
• Set to Disable .
12.Click Apply Settings . Wait until settings are applied and the Web interface
becomes active.
13.Proceed as follows:
• If the switch carries no media (iSCSI) traffic, such as for a Nearline system,
there is no need to configure VLANs. Skip to the end of this procedure.
• If the switch carries media (iSCSI) traffic, then it must have VLANs configured.
Continue with the next step in this procedure.
14.Choose VLAN Configuration . If prompted, log in with the switch’s administrator
username and password.