Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 118)

26 October 2009 K2 Storage Area Network Installation and Service Manual 118
Discovering devices with SiteConfig
reported in the Windows Services control panel.
For K2 clients and K2 Media Servers shipped new from Grass Valley with K2
software version 7.0 or higher, these requirements are pre-installed. These
requirements are pre-installed on recovery images for these K2 systems as well.
Therefore, if you suspect a problem with these requirements, do not attempt to install
SiteConfig support requirements. If you must restore SiteConfig support
requirements, re-image the K2 system.
Discovering devices with SiteConfig
Prerequisites for this task are as follows:
• The Ethernet switch or switches that the support the control network are configured
and operational. If multiple switches, ISLs are connected and trunks configured.
• The control point PC is communicating on the control network.
• There are no routers between the control point PC and the devices to be discovered.
• Devices to be discovered are Windows operating system devices, with SiteConfig
support installed.
• Devices are cabled for control network connections.
1. Open SiteConfig on the control point PC.
2. In the toolbar, click the discover devices button.
The Discover Devices dialog box opens.
A list of discovered devices is displayed.
3. Click Rescan to re-run the discovery mechanism. You can do this if a device that
you want to discover has its network connection restored or otherwise becomes
available. Additional devices discovered are added to the list.