About deploying software for the k2 san – Grass Valley K2 Summit Storage Area Network v.7.1 User Manual
Page 137
26 October 2009
K2 Storage Area Network Installation and Service Manual
137
About deploying software for the K2 SAN
on the device should be administrator/adminGV! for Aurora devices and
Administrator/adminK2 for K2 devices.
The Check Software dialog box appears. SiteConfig searches for software on the
selected device or devices and gathers information. Progress is reported.
2. When the check is complete for the selected device or devices, close the Check
Software dialog box.
An updated list of all currently installed software is displayed in the Software
Deployment | Devices | Installed Software list view. If software is a SiteConfig
managed software package, information is displayed in the Managed Package and
Deployment Group columns.
About deploying software for the K2 SAN
You must control the sequence of software deployment tasks and device restarts as
you upgrade software across the K2 SAN. The general sequence is to upgrade K2
Media Servers first then SAN K2 clients. The exact steps can vary from software
version to version. Make sure you follow the task flow in the K2 Release Notes for the
version of software to which you are upgrading.