Cable macintosh systems, Configure macintosh systems for control network – Grass Valley K2 Summit Storage Area Network v.7.1 User Manual
Page 474
26 October 2009
K2 Storage Area Network Installation and Service Manual
474
Cable Macintosh systems
username and password.
Software installs.
5. On the Xtend SAN install screen, make sure you click
Done
. If you do not do so,
the K2 FCP Connect installation stalls.
NOTE: The Xtend SAN install screen can be partially obscured behind the K2
FCP Connect install screen.
6. Click
Close
when the installation completes successfully.
Cable Macintosh systems
Connect each Macintosh system as follows. If you have mulitple Macintosh systems
and a redundant K2 SAN, balance Macintosh systems between A and B switches.
1. Connect GigE port 1 to a control port on the K2 SAN Ethernet switch.
2. Connect GigE port 2 to a media port on the K2 SAN Ethernet switch.
This connection is for the media (iSCSI) network.
Configure Macintosh systems for control network
Configure each Macintosh system as follows:
1. Open System Preferences, Network settings.