Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 313)

313 K2 Storage Area Network Installation and Service Manual 26 October 2009
File System Server
Configuration
This page checks on the
configuration of the K2
Media Server in one of its
main roles as a file system
server. The K2 Media Server
also functions as a file
system client, which is also
checked from this page.
It is not necessary to bind
RANKs or create a file
system, since this task was
completed when you
configured the previous K2
Media Server.
Click Next .
Confirm messages about copying the file system configuration file to the
other server.
If you get a “The V: will not be available until this device is rebooted…”
message, you can safely continue with this procedure and follow the
instructions related to this message later in the procedure.
iSCSI Bridge Server
Configuration
This page manages the
components that bridge
between iSCSI (the GigE
media network) and the
Fibre Channel connection to
the RAID storage. You
configure network settings
on the iSCSI adapters and
the page validates that the
Fibre Channel adapter is in
place and that the media
RANKs are visible as iSCSI
targets.
NOTE: The iSCSI
adapters on this
server must be on a
different subnet
than those on its
redundant server
partner.
Select Backup .
Select an iSCSI adapter and click Modify . A network configuration
dialog box opens. Verify or enter the media network IP address and
subnet mask and click
Apply .
Do the same for the other iSCSI adapter.
To verify drives, click
Check then View Target Drives . You should see
all your media drives listed.
Click
Next .