Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 319)

319 K2 Storage Area Network Installation and Service Manual 26 October 2009
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
NOTE: This page
does not configure
the iSCSI interface
(media network)
ports.
For systems with an optional
NH (FTP) server, the server
you ar now configuring does
not take the role of FTP
server, so configuring the
second port here for the FTP/
streaming network is not
required.
The top port is the port over which the K2 System Configuration
application is communicating with the K2 Media Server. If correctly
configured, it is already assigned the control network IP address, as
displayed on this page.
If the other port is not already configured correctly, select the other port
and click
Modify . A network configuration dialog box opens. Enter the
FTP/Streaming IP address and the subnet mask and click Apply .
Click Next .
File System Client
Configuration
This K2 Media Server does
not function as a file system
server. It does function as a
file system client, which is
validated from this page.
Click Check . When the wizard reports that the configuration check is
successful, click Next .
If you get a “The V: will not be available until this device is rebooted…”
message, you can safely continue with this procedure and follow the
instructions related to this message later in the procedure.
On this page… Do this…