Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 237)

237 K2 Storage Area Network Installation and Service Manual 26 October 2009
3. Continue with the next procedure to use Storage Utility to configure the storage
and file system.
Leave the Configure K2 Server wizard open while you are using Storage Utility.
When you are done with Storage Utility, you continue with the wizard.
Configuring RAID
Use Storage Utility to complete the configuration of the L30 RAID chassis, as
explained in the following topics:
• “Configuring RAID network and SNMP settings”
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
NOTE: This page
does not configure
the iSCSI interface
(media network)
ports.
For systems with an optional
NH (FTP) server, the server
you ar now configuring does
not take the role of FTP
server, so configuring the
second port here for the FTP/
streaming network is not
required.
The top port is the port over which the K2 System Configuration
application is communicating. If correctly configured, it is already
assigned the control network IP address, as displayed on this page.
If the server has the role of FTP server, if the other port is not already
configured correctly, select the other port and click
Modify . A network
configuration dialog box opens. Enter the FTP/Streaming IP address and
the subnet mask and click
Apply .
Click Next .
File System Server
Configuration
Click Launch Storage Manager . Storage Utility opens.
On this page… Do this…