Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 436)

26 October 2009 K2 Storage Area Network Installation and Service Manual 436
Creating K2 Coder watch folders
11.Select Create Shortcut instead of Local Copy .
12.In Retrieval Settings set Wildcard to "*", Watch Interval (sec.) to 10, Trigger File
Size (kB) to 0.
13.Click the Update button.
14.Expand Target File on the left pane, then click Add... .
15.On the right pane Preset Category, select System , then select a preset such as
K2_SD_NYSD_IFRAME_50Mbps_Template from the list.
16.Click on the Preset Editor page.
17.Set the Target Folder to V:\K2Coder\FilesToK2.
18.Click the Update button.
19.Click Save Watch to save settings and close.
The new Watch folder is added to the Carbon Admin UI. Make sure that the check
box for "Active" column is selected.
Creating the export watch folder
1. In AppCenter, create bin “K2-Coder-Export”.
2. Run Carbon Coder Admin.
3. Select Watch Folder tab.
4. Select General Properties on the left pane.
5. Enter ExportWatchFolderTemplate as the name for the Watch Folder.
The name is for display purposes only.
6. Set the Watch Folder location to V:\K2Coder\FilesFromK2.
7. Select Create New File if the target file exists.
8. Expand Remote Retrieve and then FTP Retrieve on the left pane, then click Add... .
9. On the right pane, click the Edit button.
10.In the ServerConfig window that pops up, enter localhost for FTP Server Address,
enter movie as username, 21 for FTP server port, leave Password and Use Passive
FTP empty.
11.Click Connect button.
The ServerConfig windows close automatically.
In the Watch Folder setup window, the Server Status should show “Connected to
XXX”.
12.Expand the Current Folder drop down list, select bin K2-Coder-Export then click
the Select button.
The Selected Folder should show “V:\GXF\K2-Coder-Export\”.
13.Enter “*” for Wildcard.
14.Enter 15 for Watch Interval (sec).