Configuring the level 30r k2 san, Prerequisites for initial configuration – Grass Valley K2 Summit Storage Area Network v.7.1 User Manual
Page 250
26 October 2009
K2 Storage Area Network Installation and Service Manual
250
Configuring the Level 30R K2 SAN
Configuring the Level 30R K2 SAN
Work through the topics in this section sequentially to do the initial configuration of
the Level 30R K2 SAN.
•
“Prerequisites for initial configuration” on page 250
•
“Defining a new K2 SAN” on page 251
•
“Configuring server A - Part 1” on page 253
•
“Configuring RAID” on page 255
•
“Creating a new file system” on page 261
•
“Configuring server A - Part 2” on page 263
•
“Configuring the redundant server B” on page 266
•
“Configuring optional NH servers” on page 270
Prerequisites for initial configuration
Before beginning your initial configuration, make sure the devices of the K2 SAN
meet the following prerequisites. Refer to sections earlier in this manual for detailed
information. Also refer to
Chapter 10, “Description of K2 SAN Devices”
.
Devices
Prerequisite for Level 30R configuration
Control point PC
Ethernet cable connected
Control Point software installed
Control network IP address assigned
Network communication over the control network with all other K2
devices
Power on
Ethernet switch
Ethernet cables connected
Control network IP address assigned
VLANs set up
Trunks set up
Power on
K2 Media Server
Ethernet cables connected
Fibre Channel cable connected
Redundant servers connected by serial cable
Software installed, as from the factory, including QuickTime 7
Control network IP address assigned
Power on for all servers
L30R RAID chassis
Fibre Channel cable(s) connected
Ethernet cable(s) connected
Power on
L30R RAID Expansion
chassis
(optional)
Fibre channel cable(s) connected
Power on