Prerequisites, On all macintosh client computers – Grass Valley K2 Summit Storage Area Network v.7.1 User Manual
Page 471
471
K2 Storage Area Network Installation and Service Manual
26 October 2009
Chapter 13 K2 FCP Connect access for Final Cut Pro systems
Install and configure Macintosh Final Cut Pro
systems on a K2 SAN
Read the following topics to get systems connected and file interchange operational.
Final Cut Pro on K2 SAN quick start installation checklist
Use the following sequence of tasks to set up Final Cut Pro on a K2 SAN. This
checklist assumes that the K2 SAN has been installed/commissioned and is fully
operational.
Prerequisites
On all Macintosh client computers
Task
Comment
Verify K2 SAN and Macintosh system
requirements.
—
Task
Comment
Install Final Cut Pro, if not already installed.
—
Install Xsan software, if not already
installed.
Xsan must be installed before K2 FCP
Connect.
Install K2 FCP Connect software.
The software install file is
K2FCPConnect.pkg.
Cable
network
connections.
—
Configure for control network, if not already
done.
—
Configure the hosts file for networking.
Copy in host table information from the K2
SAN's hosts file.
Configure Active Directory Domain, if
desired.
This is optional. If you do this task, you must
also enable Access Control Lists on the K2
Media Server (FSM).