Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 485)

485 K2 Storage Area Network Installation and Service Manual 26 October 2009
Chapter 13 K2 FCP Connect access for Final Cut Pro systems
This page checks the client device for required software.
8. Identify software installed on the client device and proceed as follows:
• If any software with Yes in the Required column reports as Not Installed, you
must install it on the client device. After installing the software, click Check
Software.
• If all software with Yes in the Required column reports as Installed, click Check
Software.
When all required software reports as Installed, continue with the next step in this
procedure.
9. Click Next .
The SabreTooth Server Configuration page opens.
10.Enter the K2 Media Server (FSM) as follows:
• If a basic (non-redundant) K2 SAN, enter the media file system K2 Media
Server as primary.
• If a redundant K2 SAN, enter primary and backup media file system K2 Media
Servers.
11.Click Next.
The Network Configuration page opens.
This page configures both control and media (iSCSI) network connections. The top
port is the port over which the K2 System Configuration application is
communicating with the client device. If correctly configured, it is already
assigned the control network IP address, which is displayed in the window.
12.Select the media (iSCSI) port and click Modify.
A network configuration dialog box opens.