Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 95)

26 October 2009 K2 Storage Area Network Installation and Service Manual 95
Configuring the GigE switch via the Web interface
c. For the trunked ports, set Port Enabled to Yes . On some switch models, some
ports are disabled by default, so make sure you enable them. Leave Mode as
default of
Auto .
d. Set Flow Control as follows:
- Set to Disable .
e. Click Apply Settings .
8. On the Port Configuration page, do one of the following:
• If you do not have trunks, select all ports.
• If you have trunks, select the remaining ports (the ports not trunked).