HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 531)

Message
ID
Message Text Explanation
hh...hh: Host device name
(same as HDevName of view -
path)
Action
There could be an error in the
path. See What To Do for a
Path Error on page 5-3 and
restore the path displayed in
the message to running status.
KAPL08023
-I
A path was recovered. PathID =
aa...aa, PathName =
bb...bb.cc...cc.dd...dd.ee...ee, DNum
= ff...ff, HDevName = gg...gg
Details
aa...aa: Path ID (same as
PathID of view -path) (decimal
(base-10) number)
bb...bb: Host Port number
(same as PathName of view -
path) (hexadecimal number)
cc...cc: Bus number (same as
PathName of view -path)
(hexadecimal number)
dd...dd: Target ID (same as
PathName of view -path)
(hexadecimal number)
ee...ee: HLU number (same as
PathName of view -path)
(hexadecimal number)
ff...ff: Device number (same as
DNum of view -path) (decimal
(base-10) number)
gg...gg: Host Dev name (same
as HDevName of view -path)
Action
None.
KAPL08026
-E
An error occurred on all the paths of
the LU. PathID = aa...aa
Details
An error occurred in the last,
remaining path of an LU. (This
is most likely as a result of a
disconnection.)
aa...aa: Path ID (same as
PathID of view -path) (decimal
(base-10) number)
Action
Errors are detected in all the
paths connected to the LUs.
See What To Do for a Path Error
on page 5-3 to make the path
shown in the error message or
the paths connected to the
target LU.
Messages
8-55
Hitachi Dynamic Link Manager (for Solaris) User Guide