HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 134)

19
.
Stop all nodes that comprise the cluster.
If one or more keys were displayed at step 6 and the node was started in
non-cluster mode at step 8, execute the following command on all nodes:
# shutdown -g0 -y -i0
If the nodes were started in cluster mode, execute the following
command on any one node:
# /usr/cluster/bin/scshutdown -g0 -y
20
.
With the reconfiguration option specified, start all nodes comprising the
cluster in cluster mode, at the same time.
Execute boot -r at the ok prompt.
Note
While a node is starting, the message below may be output to the
console or syslog:
Could not read symbolic link for: /dev/rdsk/c5t0d0s2 path not
loaded
This message is output because HDLM deleted the logical device file of
an sd or ssd device managed by HDLM. Perform the procedure for
updating the device ID information (steps 27 to 30) so that this
message is not output the next time the node starts. For details, refer
to the Sun Cluster documentation.
21
.
Execute the dlnkmgr command's view operation on all nodes comprising
the cluster to display the status of the programs.
The following shows an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 4096
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
3-68
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Solaris) User Guide