HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 159)

/dev/dsk/c0t0d0s0 /dev/rdsk/c0t0d0s0 / ufs 1 no -
/dev/dsk/c0t0d0s6 /dev/rdsk/c0t0d0s6 /usr ufs 1 no -
/dev/did/dsk/d24s3 /dev/did/rdsk/d24s3 /global/.devices/
node@1 ufs 2 no global
After editing
/dev/dsk/c8t50060E80004361D1d1s0 /dev/rdsk/
c8t50060E80004361D1d1s0 / ufs 1 no -
/dev/dsk/c8t50060E80004361D1d1s6 /dev/rdsk/
c8t50060E80004361D1d1s6 /usr ufs 1 no -
/dev/did/dsk/d30s3 /dev/did/rdsk/d30s3 /global/.devices/
node@1 ufs 2 no global
#
Execute the scdidadm -l command to find out the device ID to
specify as the mount device of the Sun Cluster global device file
system. In the following example, d24 is the pre-migration boot disk,
and d30 is the post-migration boot disk.
# scdidadm -l
...
24 node1:/dev/rdsk/c0t0d0 /dev/did/rdsk/d24
...
30 node1:/dev/rdsk/c8t50060E80004361D1d1 /dev/did/rdsk/d30
9
.
Edit the post-migration boot disk's /etc/vfstab file, changing the swap
device definition from the pre-migration boot disk to the post-migration
boot disk.
An example is shown below.
Before editing
/dev/dsk/c0t0d0s1 - - swap - no -
After editing
/dev/dsk/c8t50060E80004361D1d1s1 - - swap - no -
10
.
Edit the post-migration boot disk's /etc/dumpadm.conf file, changing the
dump device definition in the DUMPADM_DEVICE parameter from the pre-
migration boot disk to the post-migration boot disk.
An example is shown below.
Before editing
DUMPADM_DEVICE=/dev/dsk/c0t0d0s1
After editing
DUMPADM_DEVICE=/dev/dsk/c8t50060E80004361D1d1s1
11
.
To enable the system to boot from the post-migration environment, find
the boot device name to specify in the OpenBoot PROM (OBP).
The paths that can be specified as the boot device in the OBP depend on
the Solaris version, as follows:
¢
In Solaris 8 or Solaris 9:
Creating an HDLM Environment
3-93
Hitachi Dynamic Link Manager (for Solaris) User Guide