HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 428)

-s
Executes the command without displaying the message asking for
confirmation of command execution from the user. Specify this parameter
if you want to skip the response to the confirmation message: for
example, when you want to execute the command in a shell script or
batch file.
Example
# /opt/DynamicLinkManager/bin/dlnkmgr add -path -s
KAPL01162-I A path was added. (path ID = 00010, storage =
HITACHI.HUS100.9100163, iLU = 0030)
:
KAPL01159-I Paths were added. (number of paths added = 2,
completion time = yyyy/mm/dd hh:mm:ss)
Note:
¢
The path to be managed by HDLM must be recognized by the OS
before executing this command. Execute the following command to
make the OS recognize the path.
# cfgadm -c configure Control-ID-of-SCSI-Device
#devfsadm
¢
If you do not specify a disk label, the command might take time to
complete the processing when you execute the command.
To Display the Format of the add Operation
-help
Use this parameter to display the add operation format.
Example
# /opt/DynamicLinkManager/bin/dlnkmgr add -help
add:
Format
dlnkmgr add -path [-s]
KAPL01001-I The HDLM command completed normally. Operation name
= add, completion time = yyyy/mm/dd hh:mm:ss
#
delete (Deletes a Path Dynamically)
The dlnkmgr command's delete operation batch-removes paths from the
HDLM management targets. You can execute this command dynamically
without any effects on existing paths.
6-80
Command Reference
Hitachi Dynamic Link Manager (for Solaris) User Guide