HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 173)

c6t50060E8010027A80d8s0
-> ../../devices/pseudo/dlmndrv@1/dlmfdrv@w50060e8010027a80,8:a
2
.
Execute the zpool replace command to change the current ZFS boot
disk environment from the HDLM logical device specification to the HDLM
physical device specification.
# zpool replace root-pool-name current-boot-disk-environment-
device HDLM-physical-device
The physical device file of the HDLM device is the device file in the /
devices directory.
In the following example, the root pool name is hdlmpool, the current
boot disk environment device is c6t50060E8010027A80d7s0, and the
HDLM physical device is /devices/pseudo/dlmndrv@1/
dlmfdrv@w50060e8010027a80,8:a:
# zpool replace hdlmpool c6t50060E8010027A80d7s0
/devices/pseudo/dlmndrv@1/dlmfdrv@w50060e8010027a80,8:a
The following message appears when the command is executed, but no
action is required:
Can not determine character device path for /devices/pseudo/
dlmndrv@1/ dlmfdrv@w50060e8010253330,2:a for boot loader
installation
3
.
Execute the zpool status command to check whether replacement is
complete.
# zpool status hdlmpool
pool: hdlmpool
state: ONLINE
scan: resilvered 12.3G in 0h2m with 0 errors on Fri Dec 13
16:35:25 2013
config:
NAME STATE READ WRITE CKSUM
hdlmpool ONLINE 0 0 0
/devices/pseudo/dlmndrv@1/
dlmfdrv@w50060e8010027a80,8:a ONLINE 0 0 0
errors: No known data errors
If replacement is complete, the following message appears:
scan: resilvered XXX in XhYm with 0 errors
XhYm indicates the amount of time that elapsed before replacement
completion.
If the message above does not appear, wait for a while, and then re-
execute the command to check whether replacement is complete.
4
.
Execute the installboot command to specify the LU of the replacement
destination as the ZFS boot disk environment. Execute the following
command to allow the system to boot in a new boot disk environment:
# installboot -F zfs /usr/platform/`uname -i`/lib/fs/zfs/bootblk
post-replacement-HDLM-device
#
#
The post-replacement HDLM device is a raw device.
Creating an HDLM Environment
3-107
Hitachi Dynamic Link Manager (for Solaris) User Guide