HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 360)

online (Places Paths Online)
The dlnkmgr command's online operation places offline paths online. Specify
the paths to be placed online by specifying an HBA port, CHA port, or single
path. Instead of specifying a path, you can also specify a SCSI device name.
Format
To place paths online
/opt/DynamicLinkManager/bin/dlnkmgr online
[-path]
[-hba host-port-number.bus-number
|-hbaid HBA-port-ID
|-cha -pathid AutoPATH_ID
|-chaid CHA-port-ID
|-pathid AutoPATH_ID
|-device SCSI-device-name
|-hapath [-lu -pathid AutoPATH_ID]
|-dfha [-lu -pathid AutoPATH_ID]]
[-s]
To display the format of the online operation
/opt/DynamicLinkManager/bin/dlnkmgr online -help
Parameters
To place paths online
-path
Indicates that the target of the operation is a path managed by HDLM.
This parameter is optional because online is always used for paths, so it
is assumed.
Make sure that you specify the path to be taken online by using the -hba,
-hbaid, -cha, -chaid, -pathid, or -device parameter. If you do not
specify any of these parameters, the command will place all the offline
paths online. If there is a path that cannot be placed online, a message
asking whether you would like to continue processing will be displayed. To
ignore the offline path that cannot be placed online and to continue
processing, enter y. To stop the processing, enter n.
-hba host-port-number.bus-number
Use this parameter to place online, at one time, all the paths that pass
through a specific HBA port. The command will place online all the paths
connected to the HBA port that has the specified host port number and
bus number.
6-12
Command Reference
Hitachi Dynamic Link Manager (for Solaris) User Guide