HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 223)

Figure 3-21 An output example for the mount -p command
Edit the /etc/vfstab file as appropriate based on the settings output.
The shaded portion indicates the part of the /etc/vfstab file to set.
The following figure shows an example of how to edit the /etc/vfstab
file.
Figure 3-22 An example of how to edit the /etc/vfstab file
Add the shaded portion to the file.
Setting Up VxVM
When you are using VxVM, VxVM accesses an LU by using an HDLM device.
VxVM will automatically recognize HDLM devices. Perform setup as you would
for any other device, by following the VxVM documentation.
Creating a Disk Group
This subsection mainly describes the preparations for registering the HDLM
device in the VxVM disk group.
To register the HDLM device in the VxVM disk group, you must remove non-
HDLM devices from VxVM. If you have not yet removed non-HDLM devices,
first remove them as described in Removing Devices from VxVM on a
Controller Basis on page 3-162 or Removing Devices From VxVM on a Path
Basis on page 3-166 in Removing Devices from VxVM on page 3-160 , and
then perform the following procedure:
Creating an HDLM Environment
3-157
Hitachi Dynamic Link Manager (for Solaris) User Guide