HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 429)

Format
To Delete a Path Dynamically
/opt/DynamicLinkManager/bin/dlnkmgr delete -path [-s]
To Display the Format of the delete Operation
/opt/DynamicLinkManager/bin/dlnkmgr delete -help
Parameters
To Delete a Path Dynamically
-path
Indicates that the target of the operation is a path managed by HDLM.
Example
# /opt/DynamicLinkManager/bin/dlnkmgr delete -path
KAPL01161-I This operation will change the path configuration.
Do you want to continue? [y/n]:y
KAPL01165-I A path was deleted. (path ID = = 00010, storage =
HITACHI.HUS100.9100163, iLU = 0030)
:
KAPL01164-I Paths were deleted. (number of paths deleted = 2,
completion time = yyyy/mm/dd hh:mm:ss)
-s
Executes the command without displaying the message asking for
confirmation of command execution from the user. Specify this parameter
if you want to skip the response to the confirmation message: for
example, when you want to execute the command in a shell script or
batch file.
Example
# /opt/DynamicLinkManager/bin/dlnkmgr delete -path -s
KAPL01165-I A path was deleted. (path ID = = 00010, storage =
HITACHI.HUS100.9100163, iLU = 0030)
:
KAPL01164-I Paths were deleted. (number of paths deleted = 2,
completion time = yyyy/mm/dd hh:mm:ss)
Note:
¢
You can delete an LU via dynamic reconfiguration only in Solaris 10 or
Solaris 11.
Before executing the command, you must delete the paths to be
removed from the management target of HDLM from the OS. To do
this, configure the storage system, switch, or other device to
disconnect the LU from the host.
Perform the following operations to terminate the connection to an
existing LU:
Command Reference
6-81
Hitachi Dynamic Link Manager (for Solaris) User Guide