HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 151)

1
.
Allocate the LUs to be used by the boot disk in the post-migration
environment.
2
.
Get Solaris to recognize the LUs to be used by the post-migration boot
disk.
3
.
Set the LU slices to be used by the post-migration boot disk.
4
.
Execute the dlmsetconf utility as follows to create the HDLM driver
configuration definition file (/kernel/drv/dlmfdrv.conf) and the HDLM
driver unconfiguration definition file (/opt/DynamicLinkManager/config/
dlmfdrv.unconf):
# /opt/DynamicLinkManager/bin/dlmsetconf
This step and the next step set the LU to be used for the post-migration
boot disk as an HDLM-managed LU.
5
.
Restart the host with the reconfiguration option specified to make the
settings valid and the HDLM device recognizable.
Execute one of the following commands:
¢
# reboot -- -r
¢ boot -r (at the ok prompt)
After you finish these steps, perform the procedure described in Setting Up
the Post-Migration Environment on page 3-91 .
Migration by Installing HDLM in the Existing Local Boot Disk Environment
Perform the steps below in the pre-migration environment. The following
figure shows the workflow.
Creating an HDLM Environment
3-85
Hitachi Dynamic Link Manager (for Solaris) User Guide