HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 248)

Create these replicas on all hosts that use the shared diskset. Make sure
that all the following conditions are satisfied for the creation-target disk:
¢
The disk is not managed by HDLM.
¢
The disk is not shared.
¢
The disk is not connected via Fibre Channel.
The following shows an example of executing the command:
# metadb -a -f c1t1d0s1 c1t1d0s3 c1t1d0s7
2
.
Create a shared diskset.
The following shows an example of executing the commands:
host1# metaset -s diskset1 -a -h host1 host2
3
.
Register a disk into the shared diskset.
The following shows examples of executing the commands.
When not using Sun Cluster:
host1# metaset -s diskset1 -a c5t1d2 c5t1d3
When using Sun Cluster:
host1# metaset -s diskset1 -a /dev/did/dsk/d10 /dev/did/dsk/
d11
4
.
Create a shared volume in the shared diskset.
The following shows examples of executing the commands:
When not using Sun Cluster (stripe type):
host1# metainit -s diskset1 d1 1 2 c5t1d2s0 c5t1d3s0
When using Sun Cluster (stripe type):
host1# metainit -s diskset1 d1 1 2 /dev/did/dsk/
d10s0 /dev/did/dsk/d11s0
5
.
Create a file system on the shared volume of the shared diskset.
The following shows an example of executing the commands:
host1# newfs /dev/md/diskset1/rdsk/d1
6
.
Mount the created file system to the mount point.
The following shows examples of executing the commands. One is for a
normal mount, when Sun Cluster is not being used, and the other is for a
global mount, when Sun Cluster is being used.
When not using Sun Cluster:
3-182
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Solaris) User Guide