HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 377)

A temporary license key cannot be installed by using the dlnkmgr
command's set operation.
Example 1
The following example shows how to update the license key when the
license key file exists:
# /opt/DynamicLinkManager/bin/dlnkmgr set -lic
KAPL01049-I Would you like to execute the operation?
Operation name = set [y/n]: y
KAPL01071-I A permanent license was installed.
#
Example 2
The following example shows how to update the license key when the
license key file does not exist:
# /opt/DynamicLinkManager/bin/dlnkmgr set -lic
KAPL01049-I Would you like to execute the operation?
Operation name = set [y/n]: y
KAPL01083-I There is no license key file. File name
= /var/tmp/hdlm_license
KAPL01068-I Enter a license key:*************
KAPL01071-I A permanent license was installed.
#
-audlog {on [-audlv audit-log-data-collection-level] [-category [[ss]
[a] [ca]|all]]|off}
Specifies whether to collect audit log data.
on: Audit Log data is collected.
off: Audit Log data is not collected.
-audlv audit-log-data-collection-level
Specifies the severity level of audit log data to be collected. The table
below lists and describes the values used for this setting. The default
is 6.
Table 6-7 Values Indicating Audit Log Data Collection Levels
Value (severity) Explanation
0 No audit log data is collected.
1
2 Critical-level audit log data is collected.
3 Critical-level and Error-level audit log data is collected.
4 Critical-level, Error-level, and Warning-level audit log data is
collected.
5
6 Critical-level, Error-level, Warning-level, and Informational-level
audit log data is collected.
7
Command Reference
6-29
Hitachi Dynamic Link Manager (for Solaris) User Guide