HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 379)

Specifies the number of times the same path can be used for sequential
I/O operations when the extended Round Robin (exrr), Least I/Os
(exlio), or Least Blocks (exlbk) algorithm is used for load balancing.
You an specify a decimal (base 10) value from 0 to 999999. The default is
100.
If you specify 0, the same path is used as long as the sequential I/O
operations continue.
-dpc {on|off} [-pathid path-ID -lu | -pathid path-ID -storage]
Enables or disables the dynamic I/O path control function for each
storage system or LU. The default value is "off".
on: Enabled
off: Disabled
-pathid path-ID -lu
Sets the dynamic I/O path control function to enabled or disabled for
each LU. Specify one of the IDs of the paths connected to the target
LU.
-pathid path-ID -storage
Sets the dynamic I/O path control function to enabled or disabled for
each storage system. Specify one of the IDs of the paths connected to
the target storage system.
If the -pathid parameter is not specified, the setting is performed for
each system, and the setting for each storage system or LU is cleared.
-dpcintvl checking-interval
Specifies the checking interval (in minutes) for reviewing information
about switching of controllers performed by the storage system which is
used in the dynamic I/O path control function. Specify a value in the
range from 1 to 1440. The default value is "10".
-pstv {on|off}
Enables or disables the display of the physical storage system
information. The default value is "off".
on: Enabled
off: Disabled
If the display of the physical storage system information is enabled,
information about the physical storage system is displayed. If the display
of the physical storage system information is disabled, information about
the storage system recognized by the operating system is displayed. For
a virtualized storage system, virtual information is displayed, and for a
non-virtualized storage system, physical information is displayed.
The display results of view operations depend on whether the display of
the physical storage system information is enabled or disabled. The
following table shows the display items for which the display results differ.
Command Reference
6-31
Hitachi Dynamic Link Manager (for Solaris) User Guide