HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 363)

Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details on the view operation, see view
(Displays Information) on page 6-34 . Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID). Therefore, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you
want to add a new LU without restarting the host, AutoPATH_IDs are re-
assigned to each path of the LU when you execute the dlmcfgmgr utility.
Always make sure that you execute the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
-device SCSI-device-name
Use this parameter to place online all paths connected to the specified
SCSI device.
For SCSI-device-name, specify the value of Device displayed by
executing the view operation as follows:
# /opt/DynamicLinkManager/bin/dlnkmgr view -lu
For details on how to execute the view operation and display the SCSI
device name, see To display LU information on page 6-57 in Parameters
on page 6-36 . Only one case-sensitive parameter value can be specified.
Example
The following shows an example of how to place online all paths
whose SCSI device name is sd52 while confirming command
operation.
# /opt/DynamicLinkManager/bin/dlnkmgr online -path -device
sd52
KAPL01050-I The currently selected paths will be changed to
the Online status. Is this OK? [y/n]:y
KAPL01061-I 1 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
-hapath
Use this parameter to change to the Online status when the paths to the
primary volume (P-VOL) in an HAM environment are in the Online(S) or
Online(D) status. To change the status of a specific LU, use the -lu and
-pathid parameters to specify the path to the LU. To change the status
of all the paths in the Online(S) and Online(D) statuses, specify only -
hapath.
-dfha
Use this parameter to change the paths to the primary volume (P-VOL) in
an HAM environment to Online(D). The Online(S) status changes to the
Online(D) status. When you do not specify this parameter, the status of
the P-VOL paths in the HAM environment will be changed to the
Online(S) status. If I/O operations to the secondary volume (S-VOL)
have never occurred and only the paths to the P-VOL recover from an
error, the path to the P-VOL will be in the Online status regardless of this
Command Reference
6-15
Hitachi Dynamic Link Manager (for Solaris) User Guide