Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 82)

68 Brocade Mobility 5181 Access Point Product Reference Guide
53-1002516-01
Configuring SNMP settings
4
6. Click Apply to save any changes to the SNMP Access screen. Navigating away from the screen
without clicking the Apply button results in all changes to the screen being lost.
7. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on the SNMP Access screen to the last saved configuration.
8. Click Logout to securely exit the Mobility 5181 Access Point Access Point applet. A prompt
displays confirming the logout before the applet is closed.
For additional SNMP configuration information, see:
• Configuring SNMP access control
• Enabling SNMP traps
• Configuring specific SNMP traps
• Configuring SNMP RF trap thresholds
Configuring SNMP access control
Use the SNMP Access Control screen (as launched from the SNMP Access screen) to specify which
users can read SNMP generated information and, if capable, modify related settings from an
SNMP-capable client.
Use the SNMP Access Control screen's Access Control List (ACL) to limit, by Internet Protocol (IP)
address, who can access the Mobility 5181 Access Point SNMP interface.
NOTE
The ACL applies to both SNMP v3 user definitions and SNMP v1/v2c community definitions on the
Mobility 5181 Access Point SNMP Access screen.
To configure SNMP user access control for the Mobility 5181 Access Point:
Mobility 5181 Access
Point SNMP v3 Engine ID
The Mobility 5181 Access Point SNMP v3 Engine ID field lists the unique
SNMP v3 Engine ID for the Mobility 5181 Access Point. This ID is used in
SNMP v3 as the source for a trap, response or report. It is also used as the
destination ID when sending get, getnext, getbulk, set or inform commands.