Basic device configuration, Basic device, Configuration – Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) User Manual
Page 51
Brocade Mobility 5181 Access Point Product Reference Guide
37
53-1002516-01
Basic device configuration
3
•
Data Bits - 8
•
Stop Bits - 1
•
No Parity
•
No Flow Control
4. Press
5. Enter the default username of “admin” and the default password of “admin123.”
As this is the first time you are logging into the access point, you are prompted to enter a new
password and set the county code. Refer to
on page 397 for a list of each
available countries two digit country code.
6. At the CLI prompt (admin>), type “summary.”
The access point’s LAN IP address will display.
7. Using a Web browser, use the access point’s IP address to access the access point.
8. Refer to
on page 37 for instructions on the initial (basic)
configuration of the access point.
Basic device configuration
For the basic setup described in this section, the Java-based Web UI will be used to configure the
access point. Use the access point’s LAN interface for establishing a link with the access point.
Configure the access point as a DHCP client. For optimal screen resolution, set your screen
resolution to 1024 x 768 pixels or greater.
1. Log in using admin as the default Username and admin123 as the default Password. Use your
new password if it has been updated from default.
NOTE
For optimum compatibility, use Sun Microsystems’ JRE 1.5 or higher (available from Sun’s
Website), and be sure to disable Microsoft’s Java Virtual Machine if installed.
2. If the default login is successful, the Change Admin Password window displays. Change the
password.