Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 361)

Brocade Mobility 5181 Access Point Product Reference Guide 347
53-1002516-01
System Commands
8
File transfer : [ In progress ]
File transfer : [ Done ]
Import operation : [ Done ]
CAUTION
A single-radio model access point cannot import/export its configuration to a dual-radio model
access point. In turn, a dual-radio model access point cannot import/export its configuration to a
single-radio access point.
CAUTION
Brocade discourages importing a 1.0 baseline configuration file to a 1.1 version access point.
Similarly, a 1.1 baseline configuration file should not be imported to a 1.0 version access point.
Importing configurations between different version access point’s results in broken
configurations, since new features added to the 1.1 version access point cannot be supported in
a 1.0 version access point.
For information on importing/exporting access point configurations using the applet (GUI), see
“Importing/exporting configurations” on page 81.
Firmware Update Commands
BR5181>admin(system)>fw-update
Description
Displays the firmware update submenu. The items available under this command are shown below.
NOTE
The access point must complete the reboot process to successfully update the devicefirmware,
regardless of whether the reboot is conducted uing the GUI or CLI interfaces.
show Displays the current Mobility 5181 Access Point firmware update settings.
set Defines the Mobility 5181 Access Point firmware update parameters.
update Executes the firmware update.
.. Goes to the parent menu.
/ Goes to the root menu.
save Saves the current configuration to the Mobility 5181 Access Point system flash.
quit Quits the CLI and exits the current session.