Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 312)

298 Brocade Mobility 5181 Access Point Product Reference Guide
53-1002516-01
System Commands
8
IP Address 10 : 0.0.0.0
IP Address 11 : 0.0.0.0
IP Address 12 : 0.0.0.0
Tunnel to Controller : disable
AC Keepalive : 5
Current Controller : 157.235.22.11
AP Adoption State : TBD
admin(system.aap-setup)>
NOTE
The access point CLI is only the only AP interface that displays the adaptive AP’s adoption status and
AP run state. This information does not appear within the Adaptive AP Setup screen.
For information on configuring adaptive AP using the applet (GUI), see “Adaptive AP setup” on
page 48.
For an overview of adaptive AP functionality and its implications, see “Adaptive AP” on page 379.
BR5181>admin(system.aap-setup)>set
Description
Sets Mobility 5181 Access Point’s Adaptive AP configuration.
Syntax
For information on configuring adaptive AP using the applet (GUI), see “Adaptive AP setup” on
page 48.
For an overview of adaptive AP functionality and its implications, see “Adaptive AP” on page 379.
set auto-discovery Sets the controller auto-discovery mode (enable/disable).
interface Defines the tunnel interface.
ipadr Defines the controller IP address used.
name Defines the controller name for DNS lookups.
port Sets the port.
passphrase Defines the pass phrase or key for controller connection.
tunnel-to-controller Enables/disables the tunnel between controller and access point.
ac-keepalive Defines the keepalive interval.