Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 325)

Brocade Mobility 5181 Access Point Product Reference Guide 311
53-1002516-01
System Commands
8
Syntax
For information on configuring SNMP access settings using the applet (GUI), see “Configuring
SNMP access control” on page 68.
BR5181>admin(system.snmp.access)> delete
Description
Deletes SNMP access entries for specific v1v2 and v3 user definitions.
Syntax
add acl Adds an entry to the SNMP access control list with as the
starting IP address and and as the ending IP address.
v1v2c
: comm - community string 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
v3
: user - username 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
: sec - security - (none,auth,auth/priv)
: auth - algorithm - (md5,sha1)
: (required only if sec is - auth,auth/priv)
: pass1 - auth password - 8 to 31 chars
: (required only if sec is 'auth,auth/priv')
: priv - algorithm - (des, aes)
: (required only if sec is 'auth/priv')
: pass2 - privacy password - 8 to 31 chars
: (required only if sec is 'auth/priv')
The following parameters must be specified if is not none:
Authentication type set to md5 or sha1
Authentication password (8 to 31 chars)
The following parameters must be specified if is set to
auth/priv:
Privacy algorithm set to des or aes
Privacy password (8 to 31 chars)
delete acl Deletes entry (1-10) from the access control list.
all Deletes all entries from the access control list.
v1v2c Deletes entry (1-10) from the v1/v2 configuration list.
all Deletes all entries from the v1/v2 configuration list.