Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 314)

300 Brocade Mobility 5181 Access Point Product Reference Guide
53-1002516-01
System Commands
8
System Access Commands
BR5181>admin(system)>access
Description
Displays the access point access submenu.
BR5181>admin(system.access)>set
Description
Defines the permissions to access the Mobility 5181 Access Point applet, CLI, SNMP as well as
defining their timeout values.
Syntax
show Displays Mobility 5181 Access Point system access capabilities.
set Goes to the Mobility 5181 Access Point system access submenu.
.. Goes to the parent menu.
/ Goes to the root menu.
save Saves the current configuration to the Mobility 5181 Access Point system flash.
quit Quits the CLI and exits the current session.
set applet Defines the applet HTTP/HTTPS access parameters.
app-timeou
t > Sets the applet timeout. Default is 300 Mins.
cli Defines CLI Telnet access parameters. Enables/disables access from lan and
wan.
ssh Sets the CLI SSH access parameters.
trusted-host ,
Enables/Disables global management access (snmp, http, https, telnet and
ssh) for up to 8 addresses (hosts).
auth-timout > Disables the radio interface if no data activity is detected after the interval
defined. Default is 120 seconds.
inactive-tim
eout > Inactivity interval resulting in the AP terminating its connection.
Default is 120 minutes.
snmp Sets SNMP access parameters.
admin-auth Designates a Radius server is used in the authentication verification.
server Specifies the IP address the Remote Dial-In User Service (RADIUS) server.
port Specifies the port on which the RADIUS server is listening. Default is 1812.
secret Defines the shared secret password for RADIUS server authentication.