Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 330)

316 Brocade Mobility 5181 Access Point Product Reference Guide
53-1002516-01
System Commands
8
For information on configuring SNMP traps using the applet (GUI), see “Configuring specific SNMP
traps” on page 71.
BR5181>admin(system.snmp.traps)> add
Description
Adds SNMP trap entries.
Syntax
Example
admin(system.snmp.traps)>add v1v2 203.223.24.2 333 mycomm v1
admin(system.snmp.traps)>list v1v2c
----------------------------------------------------------------------
index dest ip dest port community version
----------------------------------------------------------------------
1 203.223.24.2 333 mycomm v1
admin(system.snmp.traps)>add v3 201.232.24.33 555 BigBoss none md5
admin(system.snmp.traps)>list v3 all
hotspot-Client-status enable/disable Enables/disables the hotspot Client
status trap.
vlan enable/disable Enables/disables VLAN traps.
lan-monitor enable/disable Enables/disables LAN monitor traps.
rate Sets the particular to monitor to
given the indicated .
See table below for information on the
possible values for , ,
and .
min-pkt Sets the minimum number of packets
required for rate traps to fire
(1-65535).
add v1v2
Adds an entry to the SNMP v1/v2 access list with the destination IP address set to , the
destination UDP port set to , the community string set to (1 to 31 characters), and
the SNMP version set to .
v3
Adds an entry to the SNMP v3 access list with the destination IP address set to , the destination
UDP port set to , the username set to (1 to 31 characters), and the authentication type
set to one of none, auth, or auth/priv.
The following parameters must be specified if is not none:
Authentication type set to md5 or sha1
Authentication password (8 to 31 chars)
The following parameters must be specified if is set to auth/priv:
Privacy algorithm set to des or aes
Privacy password (8 to 31 chars)