Configuring ap#1 – Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) User Manual
Page 387
Brocade Mobility 5181 Access Point Product Reference Guide
373
53-1002516-01
Mesh network deployment - quick setup
9
Verifying mesh network functionality for scenario #1
You now have a three AP mesh network ready to demonstrate. Associate a single Client on each AP
WLAN configured for 802.11bg radio support. Once completed, pass traffic among the three APs
comprising the mesh network.
Scenario 2 - two hop mesh network with a base
bridge repeater and a client bridge
A conceptual illustration of scenario two is as follows:
By default, the mesh algorithm runs an automatic link selection algorithm to determine the best
possible active and redundant links. If member APs are not far apart (in physical distance), the
algorithm intelligently chooses a single hop link to forward data. To force APs to use multiple hops
for demonstrations, use manual links.
In scenario 2, the following three AP configurations comprise the mesh network:
•
AP#1 is a base bridge
•
AP#2 is a repeater (client bridge/base bridge combination)
•
AP#3 is a client b ridge
Configuring AP#1
The setup of AP#1 within this usage scenario is exactly the same as the AP#1 configuration within
Scenario 1 - two base bridges and one client bridge
for step by step instructions for configuring
AP#1, see
on page 371. Once completed, return to
on page 374 within this section.