beautypg.com

3 upgrading the e-que card (mk2), Upgrading the e-que card (mk2) – Clear-Com HX System Frames User Manual

Page 98

background image

9.3 Upgrading the E-QUE card (MK2)


You must upgrade the E-QUE card (MK 2) in the following order:

1. E-QUE card application code (using the procedure described in this section).

Note:

An MVX upgrade cable is required. The procedure also requires an Ethernet connection
between the E-QUE card and the PC. If the card and the PC are not connected to the
network, they can be connected directly using a crossover Ethernet cable.

2. E-QUE card FPGA code (see 9.4 Upgrading the E-QUE card (MK1 and MK2) FPGA with

Xilinx tools).

Note:

Requires specialized equipment. For more information about installing and using Xilinx
programming tools, see Appendix I:Xilinx tools
.

3. E-QUE card (MK2) Boot PROM (if required) (see 9.6 Upgrading the E-QUE card (MK2)

boot ROM).

Figure 59: E-QUE upgrade

MVX cable connected to the
E-QUE front card.

Ethernet Crossover cable from PC LAN port >
E-QUE rear card LAN connector.

91

Eclipse HX Upgrade Guide

This manual is related to the following products: