Clear-Com HX System Frames User Manual
Page 152
Figure 112: Start Bootloader dialog
6. Ensure that Send Break Condition is checked, then press Start Bootloader.
7. The configuration dialog is re-displayed after a few seconds. In box 5, press Start.
Note:
The status bar along the bottom displays Programming device, and the progress bar
displays the state of the operation.
After about 20 seconds, Finished is displayed in the status bar. The device has now been
reprogrammed. Power cycle the TEL-14 to activate the new firmware.
145
Eclipse HX Upgrade Guide
This manual is related to the following products: