Clear-Com HX System Frames User Manual
Page 145
Figure 106: Checking the PC IP address
11. Connect an Ethernet cross-over cable from the PC to the Ethernet port at the back of the V-
series panel and disconnect the cable that connects to the matrix.
Your PC is now ready to act as a file server to a V-series panel and the panel is now ready to
be told which files to upload.
12. To upgrade the V-Series U-Boot Loader:
a. Press and hold down both the MAIN and AUX knobs on the V-Series Panel while
applying a reset.
The reset may be applied by either power cycling the panel or poking a paper clip into
the reset hole between the H/S and MENU buttons.
b. The 4 function button LEDs (Mic On, H/S, Shift and Menu) will flash. Press and
release the H/S button then press and release the Shift button to trigger the U-Boot
code upload.
Note:
As the upload proceeds, the AUX and MAIN lights on the panel will gradually change
from
green
to
amber
and then
red
. This process may take a few minutes.
c. When the upload is complete, the panel will reset itself, completing the procedure.
After the panel has reset the display will either go blank or display the versions.
138
Eclipse HX Upgrade Guide