Clear-Com HX System Frames - Manual (Page 10)

Temporary roll back strategy
If you want to roll back to the previously running version for a temporary period only, before
making another attempt to upgrade to Eclipse HX v7.5, then you may implement the following
temporary roll back strategy:
1. Leave all cards and panels at Eclipse HX v7.5.
2. Roll back the matrix CPU card to run at the previously running version.
3. Re-install the previous running version of ECS/EHX and import your old
configurations.
Caution:
The above strategy is a temporary solution only. Eclipse HX v7.5 configurations will not import
or work with a CPU card at ECS v5.2.4 or EHX v7.0/7.1. If you want to run the previously
running system software for an extended period, Clear-Com recommends rolling back all
system components to the same baseline version.
2.1.3 Supplied DVDs
Different DVD sets are supplied to the customer, according to the type of Eclipse HX product
that has been purchased:
Product Software/Documentation
DVD Hardware DVD
Matrix -
ECS / EHX -
Upgrade kit
Table 1: Supplied DVDs
Hardware DVD
The hardware DVD contains the latest firmware for your Eclipse HX devices, including Boot
PROM and FPGA / CPLD code files for Eclipse HX matrices, interface cards, interface modules
and supported panels (I-Series and V-Series panels). You must upgrade to the latest firmware
when upgrading to Eclipse HX v7.5.
The hardware DVD also includes the third party software that may be used during upgrades.
Note:
The separate and combined MVX boot and application code files (which are used to upgrade
the MVX code on both the Eclipse HX-PiCo and MVX-A16 card) are located on the software
DVD. The MVX FPGA code is located on the hardware DVD.
3 Eclipse HX Upgrade Guide