5 upgrading the e-que card (mk1) boot rom, Upgrading the e-que card (mk1) boot rom, Ee 9.5 upgrading the e-que card (mk1) – Clear-Com HX System Frames User Manual
Page 107: Boot rom )
Figure 70: Example Xilinx device programming properties
8. Right click the second device and select Programming.
The upgrade starts, and takes approximately 2 minutes to complete. When the upgrade is
complete, the Program Succeeded message is displayed in the main window.
9. Power down the UUT.
9.5 Upgrading the E-QUE card (MK1) boot ROM
Only upgrade the E-QUE (MK1) boot ROM after the main E-QUE application code has been
upgraded.
Note:
The procedure below is for E-QUE (MK1) cards only. To upgrade the PROM of an E-QUE card
(MK2), see 9.6 Upgrading the E-QUE card (MK2) boot ROM.
To upgrade the E-QUE card (MK1) boot PROM:
1. Ensure that you have the required equipment:
• 2 MBit PROM device (ST M27W201 or equivalent).
• PROM programming unit and PROM programming software appropriate for that unit.
• Appropriate ‘S’ record file. To find the file, go to:
Hardware DVD > Eclipse HX-Omega-Median-Delta > xxxxxxZ – E-Que MKI
(Green PCB) Boot ROM (where xxxxxxZ represents the part number).
.
The folder contains the *.s record file and a Read Me file (*.txt), with version
information.
2. Ensure that the PROM device to be programmed is empty.
100
Eclipse HX Upgrade Guide