Clear-Com HX System Frames - Manual (Page 154)

2. Fit the AES-6 card to either the
IMF-3 interface frame or Eclipse HX-Median Matrix. If there is
a jumper on J6, move the jumper to J3.Reset or power-cycle the card so the jumper change
takes effect.
3. Connect the serial cable to the front of the AES-6.
4. Run Flash Development Toolkit BASIC (FDT). Configure the FDT (Options > New Settings)
as follows:
FDT field Setting
Select Device H8S/2318F
Select Port COM1 (change to match COM port present on the PC)
CPU Frequency 25.0000 MHz
Connection BOOT mode
Recommended Speed Deselect Use Default and set to 9600
Protection Automatic
Messaging Advanced
User data Selected (Checked)
Table 43: FDT settings
5. Navigate to the AES-6 application code (*.mot format file) on the software DVD:
Software DVD > Other_Software > xxxxxxZ - AES-6 Application
Where xxxxxxZ represents the product number).
6. Select Program Flash and download the AES-6 application code (*.mot format file).
7. When the download is complete, move the jumper on J3 back to J6. Reset or power-cycle the
card.
Note:
If an FPGA image is present, the card will now run normally. If an FPGA image is not present,
you will be prompted for an FPGA image. See 3.33.1 Upgrading AES-6 FPGA.
147 Eclipse HX Upgrade Guide