2 upgrading the tel-14 firmware, Upgrading the tel-14 firmware – Clear-Com HX System Frames User Manual
Page 150
14.2 Upgrading the TEL-14 firmware
To upgrade the TEL-14 firmware:
1. Ensure that you have the following equipment:
Required equipment
Description / comments
MVX-A16 serial upgrade cable
(Clear-Com part CAB-MVX-48Z)
See:
Figure 28: MVX-A16 Serial upgrade cable.
Flash Magic
Third party software is available from either of the Eclipse
HX 7.5 DVDs:
• Software DVD > 3rd_Party_Software > FlashMagic
• Hardware DVD > 3rd_Party_Software >
FlashMagic
Tip:
For more information about installing Flash Magic,
*.HEX file to upload
TEL-14 application software. The TEL-14 application
software (*.HEX format file) is available from the software
DVD:
• Software DVD > Other_Software >xxxxxxZ-TEL-14
Application
Where xxxxxxZ represents the product number.
Table 40: Required equipment
2. Connect the PC to the Serial Programming port of the TEL-14 processor card, as shown in
the following figure.
Figure 110: Processor module with serial cable attached
Note:
For correct connector orientation, the wires must exit the plug on the top side as shown.
143
Eclipse HX Upgrade Guide