beautypg.com

2 changing the cpu card ram, Changing the cpu card ram – Clear-Com HX System Frames User Manual

Page 27

background image

3. Ensure that the checksum of the programmed device matches the checksum in the

Eclipse HX Release Notes.

4. Remove the existing PROM device from the CPU card.

5. Insert the newly programmed PROM device, taking care to ensure the correct polarity of the

device.

5.2 Changing the CPU card RAM

Important note:

When you change the CPU card RAM (from 128Mb RAM to 256Mb RAM), you must also change the
CPU card PROM. See
5.1 Changing the CPU card PROM above.

To change the CPU card RAM (from 128Mb to 256Mb):

1. Ensure that you have the replacement 256Mb CPU card RAM to hand.

2. Remove the CPU card from the Eclipse HX-Median, Eclipse HX-Omega or Eclipse HX-Delta

matrix.

3. The cassette that holds the CPU card RAM daughter board is located towards the center of

the main board:

Figure 9: CPU card 128Mb RAM daughter board

To release the 128Mb RAM daughter board, push back the levers to either side of the
cassette. Remove the board.

20

Eclipse HX Upgrade Guide

This manual is related to the following products: