Clear-Com HX System Frames - Manual (Page 120)

To upgrade E-MADI64 H8, DSP or FPGA code using EHX:
1. Ensure that you have the following equipment:
Required equipment Description / comments
PC with an Ethernet or serial
communications port -
EHX software EHX must be installed and configured.
Ethernet or serial cable for the
PC-to-matrix connection -
H8 application code, DSP and
FPGA code files The appropriate application code, DSP code and FPGA
code files (*.fwc format) are available from the Eclipse
HX v7.5 DVDs:
• Software DVD > Eclipse HX-Omega-Median-
Delta > E-MADI Application
• Software DVD > Eclipse HX-Omega-Median-
Delta > E-MADI DSP
• Hardware DVD > Eclipse HX-Omega-Median-
Delta > E-MADI FPGA.
Table 33: Required equipment
2. Start EHX on the PC.
3. Connect the PC to the matrix using either Ethernet or a serial communications port.
4. Open the EHX configuration map within EHX.
5. Select System > Layout.
6. Right click the matrix and then select Firmware> Update Firmware.
The Update Firmware wizard dialog is displayed. Click Next.
In the Select Hardware Type screen, ensure that the Card radio button is selected.
Figure 81: Select Hardware Type
113 Eclipse HX Upgrade Guide