Clear-Com HX System Frames - Manual (Page 116)

11 Upgrading E-MADI64 cards
This chapter describes how to upgrade E-MADI64 cards. The following E-MADI64 code can be
upgraded:
• The boot code file (*.mot), which is upgraded using the Renesas Flash Development Toolkit
3.4 Basic (FDT).
• The application code and DSP code files (*.fwc), which are upgraded using EHX.
• The FPGA code, which is upgraded using either EHX or Xilinx iMPACT programming
software.
Note:
This guide is laid out in the order in which you must upgrade your Eclipse HX software and hardware
devices. For a quick reference to upgrading your system, see
3 Quick reference: Upgrading to Eclipse HX.
11.1 Upgrading the E-MADI64 boot code
To upgrade the E-MADI64 card H8 boot code:
1. Ensure that you have the following equipment:
Required equipment Description / comments
PC with a serial port connection or
USB-to-serial port adaptor
I f you are using a USB-to-serial port adaptor, download
the latest drivers.
Renesas Flash Development
Toolkit 3.4 Basic (FDT) The Renesas FDT must be installed and configured. The
Renesas FDT application is available from both Eclipse
HX v7.5 DVDs:
Software DVD > 3rd_Party_Software > RenesasFDT
Hardware DVD > 3rd_Party_Software > RenesasFDT
MVX-A16 serial upgrade cable
(Clear-Com part CAB-MVX-48Z) For an image of this cable, see
Figure 28: MVX-A16 Serial upgrade cable.
The E-MADI64 card H8 boot
code file (*.mot):
The E-MADI64 card boot code file (*.mot) is available
from the following folder:
Hardware DVD > Eclipse HX-Omega-Median-Delta >
xxxxxxZ – E-MADI Boot (where x represents the
product number).
Table 31: Required equipment
109 Eclipse HX Upgrade Guide